APRS Track Direct

My position About ☰

reset

ON4CDR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON4CDR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780619171	272 Count	760 Count
1780618268	255 Count	721 Count
1780617365	239 Count	687 Count
1780616462	222 Count	650 Count
1780615559	209 Count	621 Count
1780614656	192 Count	580 Count
1780613753	176 Count	526 Count
1780612850	158 Count	471 Count
1780611946	143 Count	432 Count
1780611044	125 Count	355 Count
1780610140	106 Count	295 Count
1780609237	92 Count	241 Count
1780608334	78 Count	201 Count
1780607431	63 Count	159 Count
1780606528	46 Count	125 Count
1780605625	29 Count	86 Count
1780604797	14 Count	49 Count
1780603894	413 Count	1031 Count
1780602990	397 Count	997 Count
1780602087	382 Count	963 Count
1780601184	366 Count	926 Count
1780600282	351 Count	888 Count
1780599378	337 Count	848 Count
1780598475	322 Count	819 Count
1780597572	307 Count	790 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)