APRS Track Direct

My position About ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1775209682	19 Count	586 Count
1775208781	15 Count	469 Count
1775207880	11 Count	350 Count
1775206979	7 Count	272 Count
1775206078	5 Count	169 Count
1775205177	2 Count	52 Count
1775204276	28 Count	1038 Count
1775203375	24 Count	908 Count
1775202473	22 Count	791 Count
1775201572	19 Count	676 Count
1775200671	18 Count	584 Count
1775199770	13 Count	456 Count
1775198870	11 Count	355 Count
1775197969	7 Count	235 Count
1775197068	5 Count	173 Count
1775196167	2 Count	109 Count
1775195266	37 Count	1090 Count
1775194365	33 Count	983 Count
1775193464	31 Count	859 Count
1775192564	27 Count	739 Count
1775191663	24 Count	619 Count
1775190762	21 Count	563 Count
1775189861	19 Count	505 Count
1775188960	14 Count	389 Count
1775188059	8 Count	273 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)