APRS Track Direct

My position About ☰

reset

SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765037595	413 Count	58 Count	58 Count
1765037474	412 Count	58 Count	58 Count
1765037353	411 Count	58 Count	58 Count
1765037232	410 Count	58 Count	58 Count
1765037111	409 Count	58 Count	58 Count
1765036991	408 Count	58 Count	58 Count
1765036869	407 Count	58 Count	58 Count
1765036749	406 Count	58 Count	58 Count
1765036265	402 Count	58 Count	58 Count
1765036145	401 Count	58 Count	58 Count
1765036024	400 Count	58 Count	58 Count
1765035903	399 Count	58 Count	58 Count
1765035782	398 Count	58 Count	58 Count
1765035661	397 Count	58 Count	58 Count
1765035540	396 Count	58 Count	58 Count
1765035419	395 Count	58 Count	58 Count
1765035298	394 Count	58 Count	58 Count
1765035177	393 Count	58 Count	58 Count
1765035056	392 Count	58 Count	58 Count
1765034935	391 Count	58 Count	58 Count
1765034814	390 Count	58 Count	58 Count
1765034693	389 Count	58 Count	58 Count
1765034572	388 Count	58 Count	58 Count
1765034451	387 Count	58 Count	58 Count
1765034331	386 Count	58 Count	58 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)