APRS Track Direct

My position About ☰

reset

LW2DHT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791130034	746 Count	566 Count	482 Count
1791128230	741 Count	561 Count	478 Count
1791126427	730 Count	556 Count	474 Count
1791124624	725 Count	552 Count	470 Count
1791122820	720 Count	546 Count	466 Count
1791121017	715 Count	541 Count	462 Count
1791119214	710 Count	536 Count	458 Count
1791117410	705 Count	531 Count	454 Count
1791115646	700 Count	525 Count	450 Count
1791113843	695 Count	520 Count	446 Count
1791112040	690 Count	515 Count	442 Count
1791110237	685 Count	510 Count	438 Count
1791108433	680 Count	505 Count	434 Count
1791106630	675 Count	500 Count	430 Count
1791104826	670 Count	496 Count	426 Count
1791103023	665 Count	490 Count	422 Count
1791101220	660 Count	485 Count	418 Count
1791099416	655 Count	481 Count	414 Count
1791094046	640 Count	468 Count	402 Count
1791092243	635 Count	463 Count	398 Count
1791090440	630 Count	458 Count	394 Count
1791088636	625 Count	454 Count	390 Count
1791086833	620 Count	450 Count	386 Count
1791085029	615 Count	446 Count	382 Count
1791083226	610 Count	441 Count	378 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)