APRS Track Direct

My position About ☰

reset

ON3RIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON3RIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780633047	158 Count	80 Count
1780632144	142 Count	68 Count
1780631240	129 Count	65 Count
1780630337	114 Count	65 Count
1780629513	95 Count	64 Count
1780628609	79 Count	52 Count
1780627706	61 Count	41 Count
1780626803	48 Count	31 Count
1780625900	31 Count	23 Count
1780624997	17 Count	14 Count
1780624093	1006 Count	504 Count
1780623190	995 Count	485 Count
1780622286	978 Count	466 Count
1780621383	964 Count	430 Count
1780620480	946 Count	409 Count
1780619576	931 Count	383 Count
1780618673	913 Count	364 Count
1780617770	899 Count	357 Count
1780616867	882 Count	346 Count
1780615963	870 Count	343 Count
1780615060	853 Count	339 Count
1780614157	837 Count	332 Count
1780613254	820 Count	328 Count
1780612350	807 Count	314 Count
1780611445	786 Count	304 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)