APRS Track Direct

My position About ☰

reset

OE4EXE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE4EXE-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785875510	16 Count	182 Count
1785874906	15 Count	176 Count
1785874302	14 Count	165 Count
1785873698	13 Count	153 Count
1785873094	12 Count	142 Count
1785872491	11 Count	131 Count
1785871887	10 Count	116 Count
1785871284	9 Count	106 Count
1785870811	8 Count	98 Count
1785870208	7 Count	87 Count
1785869605	6 Count	76 Count
1785869001	5 Count	68 Count
1785868396	4 Count	57 Count
1785867792	3 Count	46 Count
1785867193	2 Count	36 Count
1785866585	1 Count	25 Count
1785865981	0 Count	11 Count
1785865378	111 Count	1007 Count
1785864170	109 Count	984 Count
1785863567	108 Count	976 Count
1785862963	107 Count	967 Count
1785862359	106 Count	957 Count
1785861756	105 Count	946 Count
1785861152	104 Count	937 Count
1785860548	103 Count	932 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)