APRS Track Direct

My position About ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775198226	34 Count	897 Count
1775196426	31 Count	814 Count
1775194655	30 Count	774 Count
1775192852	29 Count	747 Count
1775191049	27 Count	719 Count
1775189246	26 Count	696 Count
1775187443	25 Count	673 Count
1775185640	24 Count	642 Count
1775183837	23 Count	613 Count
1775182034	22 Count	587 Count
1775180231	21 Count	561 Count
1775178428	20 Count	534 Count
1775176625	19 Count	502 Count
1775174822	18 Count	466 Count
1775173056	17 Count	433 Count
1775171256	16 Count	401 Count
1775169449	14 Count	372 Count
1775167646	13 Count	348 Count
1775165843	12 Count	322 Count
1775164040	11 Count	297 Count
1775162237	10 Count	268 Count
1775160434	9 Count	251 Count
1775158631	8 Count	223 Count
1775156828	7 Count	175 Count
1775155025	6 Count	151 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)