APRS Track Direct

My position About ☰

reset

EC5CIA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EC5CIA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1791127878	621 Count	107 Count
1791126974	620 Count	107 Count
1791126070	619 Count	107 Count
1791125165	618 Count	107 Count
1791124261	617 Count	107 Count
1791123356	616 Count	86 Count
1791122555	615 Count	79 Count
1791121651	614 Count	79 Count
1791120746	613 Count	79 Count
1791119842	612 Count	79 Count
1791118938	611 Count	79 Count
1791118033	610 Count	79 Count
1791117129	609 Count	79 Count
1791116225	608 Count	79 Count
1791115320	607 Count	79 Count
1791114416	606 Count	79 Count
1791113512	605 Count	79 Count
1791112607	604 Count	79 Count
1791111703	603 Count	79 Count
1791110799	602 Count	79 Count
1791109894	601 Count	79 Count
1791108990	600 Count	79 Count
1791107181	598 Count	79 Count
1791106277	597 Count	79 Count
1791105373	596 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)