APRS Track Direct

My position About ☰

reset

SP5UID Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5UID. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1791105828	5 Count	1036 Count
1791102226	4 Count	889 Count
1791098627	3 Count	755 Count
1791095025	2 Count	603 Count
1791091427	1 Count	399 Count
1791087825	0 Count	212 Count
1791084226	5 Count	1007 Count
1791080625	4 Count	829 Count
1791077026	3 Count	650 Count
1791073425	2 Count	428 Count
1791069826	1 Count	209 Count
1791066225	0 Count	0 Count
1791062626	5 Count	949 Count
1791059025	4 Count	755 Count
1791055428	3 Count	561 Count
1791051827	2 Count	366 Count
1791048225	1 Count	186 Count
1791044624	0 Count	0 Count
1791041025	9 Count	971 Count
1791037423	8 Count	849 Count
1791033826	7 Count	748 Count
1791030225	6 Count	716 Count
1791026624	5 Count	626 Count
1791023023	4 Count	527 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)