APRS Track Direct

My position About ☰

reset

CE3SUR-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CE3SUR-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Sate*	Temp*	Volt*	Alt*
1732828338	12	898 C	415 V	50 M
1732825338	12	898 C	415 V	51 M
1732822338	12	898 C	415 V	50 M
1732805289	12	845 C	415 V	50 M
1732804792	12	845 C	415 V	51 M
1732804064	12	830 C	416 V	50 M
1732803842	12	820 C	412 V	51 M
1732800896	12	784 C	415 V	49 M
1732797896	12	756 C	416 V	52 M
1732796345	12	743 C	415 V	52 M
1732793947	12	741 C	415 V	52 M
1732793724	12	731 C	413 V	53 M
1732793262	12	728 C	415 V	52 M
1732790639	12	735 C	416 V	53 M
1732787637	12	740 C	416 V	52 M
1732784636	12	746 C	416 V	52 M
1732781635	12	753 C	416 V	51 M
1732778634	12	759 C	416 V	53 M
1732775631	12	766 C	415 V	52 M
1732772630	12	775 C	415 V	53 M
1732769629	12	783 C	416 V	51 M
1732766628	12	793 C	415 V	53 M
1732763628	12	805 C	416 V	52 M
1732760624	12	815 C	415 V	51 M
1732757622	12	821 C	416 V	52 M

*Used Equation Coefficients:

Sate: 0, 1, 0

Temp: 0, 1, 0

Volt: 0, 1, 0

Alt: 0, 1, 0

A5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)