APRS Track Direct

My position About ☰

reset

SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765000712	196 Count	402 Count
1764998911	195 Count	401 Count
1764997111	194 Count	400 Count
1764995310	193 Count	399 Count
1764993510	192 Count	398 Count
1764991709	191 Count	397 Count
1764989908	190 Count	396 Count
1764988108	189 Count	395 Count
1764986314	188 Count	394 Count
1764984513	187 Count	393 Count
1764982713	186 Count	392 Count
1764980912	185 Count	391 Count
1764979111	184 Count	390 Count
1764977311	183 Count	389 Count
1764975510	182 Count	388 Count
1764973710	181 Count	387 Count
1764971909	180 Count	386 Count
1764970108	179 Count	385 Count
1764968308	178 Count	384 Count
1764966507	177 Count	383 Count
1764964713	176 Count	383 Count
1764962912	175 Count	382 Count
1764961111	174 Count	349 Count
1764959311	173 Count	348 Count
1764957510	172 Count	347 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)