APRS Track Direct

My position About ☰

reset

SR2ST-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ST-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1785859912	298 Count	178 Count	121 Count
1785858231	255 Count	153 Count	103 Count
1785856550	179 Count	105 Count	69 Count
1785854869	138 Count	82 Count	52 Count
1785853189	115 Count	64 Count	46 Count
1785851508	82 Count	43 Count	33 Count
1785849827	41 Count	21 Count	17 Count
1785848146	1041 Count	548 Count	434 Count
1785846466	996 Count	522 Count	416 Count
1785844785	975 Count	510 Count	409 Count
1785843104	956 Count	500 Count	403 Count
1785841423	912 Count	477 Count	385 Count
1785839742	796 Count	429 Count	342 Count
1785838311	748 Count	405 Count	323 Count
1785836630	663 Count	359 Count	284 Count
1785834949	545 Count	299 Count	229 Count
1785833268	468 Count	253 Count	196 Count
1785831588	412 Count	224 Count	172 Count
1785829907	371 Count	200 Count	155 Count
1785828226	311 Count	169 Count	129 Count
1785826545	256 Count	141 Count	106 Count
1785824864	231 Count	126 Count	97 Count
1785823184	183 Count	100 Count	77 Count
1785821503	134 Count	73 Count	56 Count
1785819822	75 Count	42 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)