APRS Track Direct

My position About ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785880909	346 Count	437 Count	198 Count
1785880308	340 Count	416 Count	193 Count
1785879707	335 Count	397 Count	189 Count
1785879107	331 Count	383 Count	186 Count
1785877906	321 Count	348 Count	178 Count
1785877305	317 Count	337 Count	175 Count
1785876704	313 Count	318 Count	172 Count
1785876105	308 Count	302 Count	168 Count
1785875504	304 Count	285 Count	165 Count
1785874903	300 Count	267 Count	162 Count
1785874302	295 Count	245 Count	158 Count
1785873701	291 Count	231 Count	155 Count
1785873100	286 Count	212 Count	152 Count
1785845264	269 Count	229 Count	192 Count
1785845203	266 Count	227 Count	190 Count
1785843443	155 Count	132 Count	108 Count
1785842532	103 Count	86 Count	71 Count
1785840407	986 Count	911 Count	739 Count
1785840165	965 Count	892 Count	722 Count
1785839923	951 Count	880 Count	712 Count
1785839862	949 Count	879 Count	711 Count
1785839741	941 Count	871 Count	705 Count
1785839620	935 Count	866 Count	701 Count
1785837981	845 Count	789 Count	638 Count
1785837860	840 Count	786 Count	635 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)