APRS Track Direct

My position About ☰

reset

N0BII-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object N0BII-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785862144	205 Count	564 Count	115 Count
1785860341	197 Count	557 Count	108 Count
1785858537	188 Count	547 Count	100 Count
1785856793	179 Count	534 Count	92 Count
1785854990	170 Count	526 Count	84 Count
1785853186	161 Count	518 Count	76 Count
1785851382	152 Count	510 Count	68 Count
1785849579	143 Count	502 Count	60 Count
1785847775	134 Count	494 Count	52 Count
1785845971	125 Count	486 Count	44 Count
1785844167	116 Count	478 Count	36 Count
1785842363	107 Count	470 Count	28 Count
1785840559	104 Count	461 Count	26 Count
1785838756	103 Count	450 Count	26 Count
1785836952	102 Count	427 Count	26 Count
1785835148	101 Count	398 Count	26 Count
1785833344	100 Count	383 Count	26 Count
1785831540	99 Count	375 Count	26 Count
1785829736	98 Count	353 Count	26 Count
1785828787	97 Count	353 Count	26 Count
1785826984	96 Count	345 Count	26 Count
1785825180	95 Count	337 Count	26 Count
1785823376	94 Count	330 Count	26 Count
1785814891	93 Count	312 Count	26 Count
1785813088	92 Count	301 Count	26 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)