APRS Track Direct

My position About ☰

reset

SP8SD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8SD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1786394730	27 Count	51 Count	24 Count
1786394429	20 Count	37 Count	18 Count
1786394129	13 Count	24 Count	12 Count
1786393836	8 Count	15 Count	8 Count
1786393527	554 Count	1011 Count	489 Count
1786393227	546 Count	995 Count	482 Count
1786392926	539 Count	983 Count	476 Count
1786392626	530 Count	968 Count	468 Count
1786392325	527 Count	962 Count	466 Count
1786392025	519 Count	951 Count	459 Count
1786391724	509 Count	931 Count	450 Count
1786391123	482 Count	883 Count	425 Count
1786390822	470 Count	859 Count	414 Count
1786390522	460 Count	844 Count	405 Count
1786390222	444 Count	811 Count	390 Count
1786389919	428 Count	783 Count	375 Count
1786389619	411 Count	749 Count	359 Count
1786389318	400 Count	728 Count	349 Count
1786389019	395 Count	713 Count	345 Count
1786388717	387 Count	698 Count	338 Count
1786388416	381 Count	686 Count	333 Count
1786388116	374 Count	671 Count	327 Count
1786387815	369 Count	660 Count	323 Count
1786387515	361 Count	648 Count	316 Count
1786387214	351 Count	625 Count	307 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 1, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)