APRS Track Direct

My position About ☰

reset

SV1SSF-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775224636	3 Count	68 Count
1775222833	1 Count	38 Count
1775221030	52 Count	1019 Count
1775219226	51 Count	984 Count
1775217423	50 Count	960 Count
1775215620	49 Count	929 Count
1775213816	47 Count	896 Count
1775212054	45 Count	869 Count
1775210251	42 Count	839 Count
1775208447	38 Count	808 Count
1775206644	36 Count	783 Count
1775204843	35 Count	755 Count
1775203037	34 Count	740 Count
1775201233	33 Count	711 Count
1775199429	30 Count	671 Count
1775197626	29 Count	637 Count
1775195822	28 Count	607 Count
1775194019	26 Count	580 Count
1775192215	25 Count	545 Count
1775190506	24 Count	513 Count
1775188703	22 Count	483 Count
1775186899	21 Count	457 Count
1775185096	20 Count	426 Count
1775183293	19 Count	401 Count
1775181489	18 Count	368 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)