APRS Track Direct

My position About ☰

reset

4K6AG-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4K6AG-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1770047285	778 Count	32 Count	32 Count
1770046076	776 Count	32 Count	32 Count
1770045474	775 Count	32 Count	32 Count
1770044869	774 Count	32 Count	32 Count
1770044266	773 Count	32 Count	32 Count
1770043661	772 Count	32 Count	32 Count
1770043058	771 Count	32 Count	32 Count
1770042454	770 Count	32 Count	32 Count
1770041850	769 Count	32 Count	32 Count
1770040644	767 Count	32 Count	32 Count
1770040042	766 Count	32 Count	32 Count
1770039440	765 Count	32 Count	32 Count
1770038835	764 Count	32 Count	32 Count
1770038229	763 Count	32 Count	32 Count
1770037628	762 Count	32 Count	32 Count
1770036445	760 Count	32 Count	32 Count
1770035815	759 Count	32 Count	32 Count
1770035211	758 Count	32 Count	32 Count
1770034607	757 Count	32 Count	32 Count
1770034004	756 Count	32 Count	32 Count
1770033400	755 Count	32 Count	32 Count
1770032797	754 Count	32 Count	32 Count
1770032194	753 Count	32 Count	32 Count
1770031126	751 Count	32 Count	32 Count
1770030387	749 Count	31 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)