APRS Track Direct

My position About ☰

reset

SP8RPA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8RPA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1780594686	675 Count	835 Count	609 Count
1780589897	595 Count	747 Count	537 Count
1780587495	557 Count	703 Count	501 Count
1780585093	536 Count	671 Count	482 Count
1780582692	513 Count	645 Count	461 Count
1780580290	493 Count	618 Count	443 Count
1780577888	476 Count	600 Count	428 Count
1780573085	424 Count	541 Count	380 Count
1780558689	251 Count	355 Count	223 Count
1780553885	211 Count	305 Count	187 Count
1780551484	195 Count	287 Count	173 Count
1780546695	158 Count	237 Count	144 Count
1780544293	120 Count	158 Count	108 Count
1780541891	85 Count	103 Count	75 Count
1780539490	69 Count	80 Count	61 Count
1780537088	55 Count	66 Count	49 Count
1780534686	41 Count	54 Count	37 Count
1780532284	25 Count	33 Count	23 Count
1780529883	6 Count	8 Count	6 Count
1780525094	765 Count	954 Count	722 Count
1780522692	742 Count	930 Count	701 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)