APRS Track Direct

My position About ☰

reset

DL7AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DL7AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1780634099	3576	1492	54	1234	7999
1780633802	3576	1536	53	1233	7998
1780633499	3576	1348	53	1233	7997
1780633200	3576	1253	54	1234	7997
1780632900	3576	1049	53	1234	7996
1780632600	3576	1157	53	1234	7996
1780632301	3576	864	54	1236	7995
1780632000	3576	743	52	1234	7995
1780631701	3576	739	52	1234	7996
1780631401	3576	814	53	1236	7994
1780631100	3576	510	52	1234	7994
1780630801	3576	481	52	1235	7993
1780630500	3576	488	53	1237	7993
1780630201	3576	499	52	1236	7992
1780629601	3576	473	52	1236	7993
1780629301	3576	472	52	1236	7992
1780629002	3576	472	53	1238	7992
1780627802	3576	336	54	1237	7987
1780627501	3584	336	52	1238	7986
1780627202	3584	336	53	1239	7986
1780626902	3584	336	52	1238	7986
1780626301	3569	329	53	1238	7986
1780626002	3584	304	54	1239	7986
1780625702	3584	168	52	1239	7986
1780625402	3584	104	49	1240	7986

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)