APRS Track Direct

My position About ☰

reset

SP4WSL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4WSL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791163545	295 Count	360 Count	280 Count
1791161745	275 Count	335 Count	261 Count
1791159954	258 Count	314 Count	245 Count
1791156353	227 Count	274 Count	216 Count
1791154551	209 Count	249 Count	199 Count
1791152750	185 Count	221 Count	176 Count
1791150949	167 Count	197 Count	159 Count
1791149149	149 Count	175 Count	142 Count
1791147348	127 Count	149 Count	121 Count
1791145547	107 Count	125 Count	102 Count
1791143747	86 Count	100 Count	82 Count
1791141946	64 Count	74 Count	61 Count
1791140145	43 Count	48 Count	41 Count
1791138741	42 Count	48 Count	41 Count
1791136940	20 Count	23 Count	20 Count
1791135140	842 Count	1022 Count	783 Count
1791133339	821 Count	999 Count	763 Count
1791131538	797 Count	971 Count	740 Count
1791129744	778 Count	950 Count	722 Count
1791127943	757 Count	928 Count	702 Count
1791126142	740 Count	906 Count	686 Count
1791124342	721 Count	883 Count	668 Count
1791122541	702 Count	861 Count	650 Count
1791120740	681 Count	838 Count	630 Count
1791118940	660 Count	814 Count	610 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)