APRS Track Direct

My position About ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791142581	274 Count	608 Count	129 Count
1791142280	270 Count	601 Count	127 Count
1791141980	268 Count	596 Count	126 Count
1791141679	265 Count	585 Count	125 Count
1791141378	263 Count	582 Count	124 Count
1791141077	259 Count	574 Count	122 Count
1791140777	258 Count	571 Count	122 Count
1791140476	254 Count	566 Count	120 Count
1791140175	252 Count	562 Count	119 Count
1791139874	249 Count	551 Count	118 Count
1791139573	247 Count	549 Count	117 Count
1791139273	237 Count	530 Count	109 Count
1791138972	231 Count	515 Count	104 Count
1791138671	222 Count	498 Count	97 Count
1791138371	219 Count	491 Count	95 Count
1791138069	216 Count	484 Count	94 Count
1791137768	214 Count	481 Count	93 Count
1791137468	210 Count	473 Count	91 Count
1791137167	209 Count	469 Count	91 Count
1791136866	205 Count	462 Count	89 Count
1791136565	203 Count	457 Count	88 Count
1791136265	200 Count	449 Count	87 Count
1791135964	198 Count	446 Count	86 Count
1791135663	194 Count	437 Count	84 Count
1791135362	193 Count	433 Count	84 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)