APRS Track Direct

My position About ☰

reset

SP2KDS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2KDS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785854431	41 Count	491 Count
1785852630	38 Count	449 Count
1785850829	34 Count	412 Count
1785849029	30 Count	372 Count
1785847228	27 Count	338 Count
1785845428	24 Count	301 Count
1785843627	22 Count	260 Count
1785841857	13 Count	213 Count
1785840056	7 Count	169 Count
1785838255	2 Count	87 Count
1785836455	84 Count	1036 Count
1785834654	61 Count	924 Count
1785832853	52 Count	851 Count
1785831053	36 Count	724 Count
1785829252	29 Count	622 Count
1785827452	22 Count	514 Count
1785825651	12 Count	374 Count
1785823852	6 Count	217 Count
1785822050	2 Count	100 Count
1785820249	1 Count	58 Count
1785818448	0 Count	32 Count
1785816648	26 Count	1002 Count
1785814847	25 Count	970 Count
1785813046	24 Count	937 Count
1785811245	23 Count	909 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)