APRS Track Direct

My position About ☰

reset

EA5GVP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5GVP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Pressure*	Humidity*
1765015739	158	8280	37
1765015139	158	8280	37
1765014539	158	8280	37
1765013339	158	8280	37
1765012739	158	8280	37
1765012139	158	8280	37
1765011539	158	8280	37
1765010939	158	8280	37
1765010339	158	8280	37
1765009739	158	8280	37
1765009139	158	8280	37
1765008539	158	8280	37
1765007939	158	8280	37
1765007339	158	8280	37
1765006739	158	8280	37
1765006139	158	8280	37
1765005539	158	8280	37
1765004939	158	8280	37
1765004339	158	8280	37
1765003739	158	8280	37
1765003139	158	8280	37
1765002539	158	8280	37
1765001939	158	8280	37
1765001339	158	8280	37
1765000739	158	8280	37

*Used Equation Coefficients:

Temp: 0, 1, 0

Pressure: 0, 1, 0

Humidity: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)