APRS Track Direct

My position About ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1775221329	83 Count	526 Count
1775217726	78 Count	498 Count
1775214123	73 Count	452 Count
1775210520	68 Count	411 Count
1775206917	63 Count	370 Count
1775203314	58 Count	338 Count
1775199711	53 Count	312 Count
1775196108	48 Count	273 Count
1775192505	43 Count	243 Count
1775188902	38 Count	219 Count
1775185300	33 Count	196 Count
1775181731	28 Count	169 Count
1775178128	23 Count	140 Count
1775174525	19 Count	110 Count
1775170922	14 Count	87 Count
1775167319	9 Count	59 Count
1775163716	4 Count	28 Count
1775160113	150 Count	1014 Count
1775156510	145 Count	986 Count
1775152907	140 Count	935 Count
1775149307	126 Count	877 Count
1775145704	121 Count	836 Count
1775138531	111 Count	743 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)