APRS Track Direct

My position About ☰

reset

SR2ZXT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZXT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780640946	89 Count	209 Count	73 Count
1780639146	84 Count	199 Count	69 Count
1780637345	79 Count	189 Count	65 Count
1780635546	74 Count	174 Count	61 Count
1780633751	66 Count	160 Count	54 Count
1780631950	61 Count	149 Count	50 Count
1780630150	56 Count	138 Count	46 Count
1780628349	51 Count	128 Count	42 Count
1780626548	46 Count	118 Count	38 Count
1780624748	41 Count	100 Count	34 Count
1780622947	36 Count	87 Count	30 Count
1780621146	31 Count	76 Count	26 Count
1780619346	26 Count	64 Count	22 Count
1780617545	21 Count	54 Count	18 Count
1780615744	16 Count	42 Count	14 Count
1780613944	11 Count	26 Count	10 Count
1780612149	4 Count	12 Count	4 Count
1780610349	445 Count	1003 Count	361 Count
1780608548	440 Count	991 Count	357 Count
1780606747	435 Count	979 Count	353 Count
1780604947	428 Count	966 Count	347 Count
1780603146	421 Count	949 Count	341 Count
1780601345	408 Count	930 Count	329 Count
1780599545	400 Count	915 Count	322 Count
1780597744	393 Count	901 Count	316 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)