APRS Track Direct

My position About ☰

reset

S51ZK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object S51ZK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1785839241	178 Count	1000 Count	107 Count
1785835657	177 Count	1000 Count	107 Count
1785832054	176 Count	1000 Count	107 Count
1785828450	175 Count	1000 Count	107 Count
1785824847	174 Count	1000 Count	107 Count
1785821244	173 Count	1000 Count	107 Count
1785817641	172 Count	1000 Count	107 Count
1785814056	171 Count	1000 Count	107 Count
1785810453	170 Count	1000 Count	107 Count
1785806850	169 Count	1000 Count	107 Count
1785803247	168 Count	1000 Count	107 Count
1785799643	167 Count	1000 Count	107 Count
1785796040	166 Count	1000 Count	107 Count
1785792455	165 Count	1000 Count	107 Count
1785788851	164 Count	1000 Count	107 Count
1785785248	163 Count	1000 Count	107 Count
1785781645	162 Count	1000 Count	107 Count
1785778042	159 Count	998 Count	105 Count
1785774438	158 Count	998 Count	105 Count
1785770854	157 Count	998 Count	105 Count
1785767251	156 Count	998 Count	105 Count
1785763648	155 Count	998 Count	105 Count
1785760045	154 Count	998 Count	105 Count
1785756441	153 Count	998 Count	105 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)