APRS Track Direct

My position About ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780620677	194 Count	868 Count	161 Count
1780618876	182 Count	793 Count	150 Count
1780617075	175 Count	735 Count	144 Count
1780615275	164 Count	670 Count	134 Count
1780611673	151 Count	581 Count	123 Count
1780600869	115 Count	380 Count	93 Count
1780595474	90 Count	301 Count	75 Count
1780593673	84 Count	279 Count	70 Count
1780591873	79 Count	256 Count	66 Count
1780590072	71 Count	232 Count	59 Count
1780588271	66 Count	207 Count	55 Count
1780586470	59 Count	182 Count	49 Count
1780584670	54 Count	161 Count	45 Count
1780582869	49 Count	131 Count	41 Count
1780581068	43 Count	111 Count	36 Count
1780579267	37 Count	83 Count	31 Count
1780577475	28 Count	64 Count	27 Count
1780575674	20 Count	40 Count	20 Count
1780573873	297 Count	1019 Count	252 Count
1780572072	287 Count	993 Count	243 Count
1780570271	277 Count	958 Count	234 Count
1780568471	271 Count	925 Count	229 Count
1780566670	265 Count	900 Count	224 Count
1780563068	210 Count	805 Count	171 Count
1780559467	195 Count	737 Count	158 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)