APRS Track Direct

My position About ☰

reset

SP7TWA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TWA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785847971	31 Count	350 Count
1785847070	30 Count	348 Count
1785846169	29 Count	347 Count
1785845268	28 Count	345 Count
1785844367	27 Count	344 Count
1785843466	26 Count	342 Count
1785842566	25 Count	341 Count
1785841665	24 Count	340 Count
1785840764	23 Count	339 Count
1785839863	22 Count	337 Count
1785838962	21 Count	336 Count
1785838062	20 Count	334 Count
1785837161	19 Count	333 Count
1785836260	18 Count	327 Count
1785835359	17 Count	325 Count
1785834458	16 Count	322 Count
1785833558	15 Count	318 Count
1785832657	14 Count	315 Count
1785831756	13 Count	307 Count
1785830855	12 Count	304 Count
1785829954	11 Count	297 Count
1785829668	10 Count	295 Count
1785828767	9 Count	288 Count
1785827866	8 Count	281 Count
1785826966	7 Count	264 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)