APRS Track Direct

My position About ☰

reset

IT9IRS-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IRS-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791140432	366 Count	570 Count	295 Count
1791139827	363 Count	562 Count	293 Count
1791139222	357 Count	542 Count	288 Count
1791138618	352 Count	528 Count	284 Count
1791138013	348 Count	517 Count	281 Count
1791137409	345 Count	510 Count	279 Count
1791136803	339 Count	494 Count	274 Count
1791136198	336 Count	490 Count	272 Count
1791135593	332 Count	479 Count	269 Count
1791134989	325 Count	471 Count	263 Count
1791134384	323 Count	465 Count	262 Count
1791133779	319 Count	457 Count	259 Count
1791133175	314 Count	448 Count	255 Count
1791132570	312 Count	442 Count	254 Count
1791131965	308 Count	433 Count	251 Count
1791131360	303 Count	428 Count	247 Count
1791130756	301 Count	425 Count	246 Count
1791130151	297 Count	418 Count	243 Count
1791129546	294 Count	411 Count	241 Count
1791128942	281 Count	394 Count	229 Count
1791128336	261 Count	364 Count	210 Count
1791127732	253 Count	355 Count	203 Count
1791127127	249 Count	350 Count	200 Count
1791126522	244 Count	344 Count	196 Count
1791125918	240 Count	338 Count	193 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)