APRS Track Direct

My position About ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791143180	55 Count	593 Count
1791142281	54 Count	585 Count
1791141378	53 Count	576 Count
1791140478	52 Count	568 Count
1791139572	51 Count	560 Count
1791138671	50 Count	552 Count
1791137771	49 Count	542 Count
1791136870	48 Count	532 Count
1791135969	47 Count	522 Count
1791135069	46 Count	511 Count
1791134168	45 Count	501 Count
1791111116	19 Count	205 Count
1791110215	18 Count	196 Count
1791109314	17 Count	186 Count
1791108413	16 Count	176 Count
1791106612	14 Count	156 Count
1791105711	13 Count	145 Count
1791104811	12 Count	135 Count
1791103910	11 Count	124 Count
1791103009	10 Count	113 Count
1791102108	9 Count	103 Count
1791101207	8 Count	92 Count
1791100307	7 Count	81 Count
1791099405	6 Count	70 Count
1791098504	5 Count	60 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)