APRS Track Direct

My position About ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791130138	12 Count	6 Count	6 Count
1791129234	10 Count	5 Count	5 Count
1791128331	8 Count	4 Count	4 Count
1791127427	6 Count	3 Count	3 Count
1791126523	4 Count	2 Count	2 Count
1791125619	2 Count	1 Count	1 Count
1791124716	0 Count	0 Count	0 Count
1791123903	999 Count	725 Count	549 Count
1791122999	997 Count	724 Count	548 Count
1791122096	995 Count	723 Count	547 Count
1791121191	993 Count	722 Count	546 Count
1791120288	991 Count	721 Count	545 Count
1791119384	989 Count	720 Count	544 Count
1791118480	987 Count	719 Count	543 Count
1791117576	985 Count	718 Count	542 Count
1791116672	983 Count	717 Count	541 Count
1791115769	981 Count	716 Count	540 Count
1791114865	979 Count	715 Count	539 Count
1791113961	977 Count	714 Count	538 Count
1791113057	975 Count	713 Count	537 Count
1791112154	973 Count	712 Count	536 Count
1791111249	971 Count	711 Count	535 Count
1791110346	969 Count	710 Count	534 Count
1791109442	967 Count	707 Count	533 Count
1791108538	958 Count	680 Count	525 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)