APRS Track Direct

My position About ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1765014561	67 Count	481 Count
1765013144	65 Count	471 Count
1765011336	63 Count	454 Count
1765009527	61 Count	441 Count
1765007718	59 Count	426 Count
1765005909	57 Count	407 Count
1765004101	55 Count	393 Count
1765002292	53 Count	377 Count
1765000484	51 Count	359 Count
1764998676	49 Count	342 Count
1764996972	47 Count	327 Count
1764995163	45 Count	309 Count
1764993355	43 Count	295 Count
1764991546	41 Count	277 Count
1764989738	39 Count	267 Count
1764987930	37 Count	254 Count
1764986121	35 Count	241 Count
1764984312	33 Count	226 Count
1764982504	31 Count	209 Count
1764980695	29 Count	196 Count
1764978886	26 Count	177 Count
1764977078	24 Count	167 Count
1764975369	22 Count	157 Count
1764973560	20 Count	136 Count
1764971752	18 Count	124 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)