APRS Track Direct

My position About ☰

reset

SP9KPS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KPS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791163284	241 Count	931 Count	238 Count
1791161483	176 Count	690 Count	174 Count
1791159682	117 Count	465 Count	116 Count
1791157879	58 Count	241 Count	58 Count
1791156089	303 Count	1202 Count	299 Count
1791154288	243 Count	978 Count	240 Count
1791152486	181 Count	732 Count	179 Count
1791150684	115 Count	501 Count	114 Count
1791148883	60 Count	255 Count	60 Count
1791147082	194 Count	1249 Count	187 Count
1791145282	134 Count	986 Count	128 Count
1791143481	98 Count	800 Count	93 Count
1791141680	79 Count	619 Count	75 Count
1791139879	67 Count	414 Count	64 Count
1791138078	31 Count	207 Count	30 Count
1791136278	0 Count	0 Count	0 Count
1791134486	106 Count	863 Count	101 Count
1791132686	78 Count	657 Count	74 Count
1791130885	63 Count	488 Count	60 Count
1791129084	35 Count	291 Count	34 Count
1791127283	15 Count	139 Count	15 Count
1791125482	130 Count	1099 Count	120 Count
1791123682	114 Count	983 Count	105 Count
1791121881	98 Count	907 Count	90 Count
1791120080	85 Count	826 Count	78 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)