APRS Track Direct

My position About ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1780641403	406 Count	618 Count	74 Count
1780640202	404 Count	618 Count	74 Count
1780639000	402 Count	618 Count	74 Count
1780637799	400 Count	618 Count	74 Count
1780637197	399 Count	618 Count	74 Count
1780636596	398 Count	618 Count	74 Count
1780635996	397 Count	618 Count	74 Count
1780634794	395 Count	618 Count	74 Count
1780634193	394 Count	618 Count	74 Count
1780633592	393 Count	618 Count	74 Count
1780632991	392 Count	618 Count	74 Count
1780632421	387 Count	618 Count	74 Count
1780631820	386 Count	618 Count	74 Count
1780631219	385 Count	618 Count	74 Count
1780630619	384 Count	618 Count	74 Count
1780630018	383 Count	618 Count	74 Count
1780629417	382 Count	617 Count	74 Count
1780628816	381 Count	617 Count	74 Count
1780628215	380 Count	614 Count	74 Count
1780627614	378 Count	609 Count	73 Count
1780627013	377 Count	604 Count	73 Count
1780626413	376 Count	592 Count	73 Count
1780625812	375 Count	572 Count	73 Count
1780625211	374 Count	568 Count	73 Count
1780624610	372 Count	558 Count	72 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)