APRS Track Direct

My position About ☰

reset

SP5MSV-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5MSV-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780640148	76 Count	564 Count	48 Count
1780638347	73 Count	560 Count	46 Count
1780636547	70 Count	557 Count	44 Count
1780634746	67 Count	548 Count	42 Count
1780632945	64 Count	544 Count	40 Count
1780631153	61 Count	536 Count	38 Count
1780629352	58 Count	523 Count	36 Count
1780627551	55 Count	521 Count	34 Count
1780625751	52 Count	516 Count	32 Count
1780623950	49 Count	512 Count	30 Count
1780622149	46 Count	506 Count	28 Count
1780620348	43 Count	503 Count	26 Count
1780618548	40 Count	498 Count	24 Count
1780616747	37 Count	485 Count	22 Count
1780614946	35 Count	462 Count	21 Count
1780613146	33 Count	435 Count	20 Count
1780611345	30 Count	406 Count	18 Count
1780609552	28 Count	376 Count	17 Count
1780607752	26 Count	344 Count	16 Count
1780605951	24 Count	323 Count	15 Count
1780604150	21 Count	289 Count	13 Count
1780602349	18 Count	258 Count	11 Count
1780600549	16 Count	229 Count	10 Count
1780598748	13 Count	196 Count	8 Count
1780596947	12 Count	156 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)