APRS Track Direct

My position About ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1765012201	581 Count	88 Count	62 Count
1765010274	578 Count	87 Count	61 Count
1765008347	541 Count	52 Count	26 Count
1765006420	536 Count	49 Count	23 Count
1765004493	534 Count	49 Count	23 Count
1765002566	532 Count	49 Count	23 Count
1765000234	529 Count	49 Count	23 Count
1764998307	527 Count	49 Count	23 Count
1764996380	525 Count	49 Count	23 Count
1764994454	523 Count	49 Count	23 Count
1764992527	521 Count	49 Count	23 Count
1764990600	519 Count	49 Count	23 Count
1764988673	517 Count	49 Count	23 Count
1764986747	515 Count	49 Count	23 Count
1764984820	513 Count	49 Count	23 Count
1764982893	511 Count	49 Count	23 Count
1764980966	509 Count	49 Count	23 Count
1764979040	507 Count	49 Count	23 Count
1764978632	506 Count	49 Count	23 Count
1764976706	504 Count	49 Count	23 Count
1764974779	502 Count	49 Count	23 Count
1764972852	500 Count	49 Count	23 Count
1764970926	498 Count	49 Count	23 Count
1764968999	496 Count	49 Count	23 Count
1764967072	494 Count	49 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)