APRS Track Direct

My position About ☰

reset

IZ5IOM-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ5IOM-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791118694	2 Count	195 Count
1791116890	1 Count	120 Count
1791115087	0 Count	60 Count
1791113283	18 Count	1036 Count
1791111480	17 Count	979 Count
1791109677	16 Count	926 Count
1791107873	15 Count	873 Count
1791106070	14 Count	813 Count
1791104266	13 Count	756 Count
1791102504	12 Count	702 Count
1791100700	11 Count	651 Count
1791098896	10 Count	604 Count
1791095290	8 Count	510 Count
1791093486	7 Count	444 Count
1791091683	6 Count	398 Count
1791089879	5 Count	343 Count
1791088076	4 Count	280 Count
1791086273	3 Count	215 Count
1791084469	2 Count	159 Count
1791082666	1 Count	110 Count
1791080903	0 Count	57 Count
1791079099	17 Count	1031 Count
1791077296	16 Count	975 Count
1791075492	15 Count	916 Count
1791073689	14 Count	857 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)