APRS Track Direct

My position About ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780625910	600 Count	490 Count	89 Count
1780624106	599 Count	490 Count	89 Count
1780622302	598 Count	490 Count	89 Count
1780620499	597 Count	490 Count	89 Count
1780618695	596 Count	490 Count	89 Count
1780616891	595 Count	490 Count	89 Count
1780613284	593 Count	490 Count	89 Count
1780611480	592 Count	490 Count	89 Count
1780609677	591 Count	490 Count	89 Count
1780607873	590 Count	488 Count	89 Count
1780606069	589 Count	488 Count	89 Count
1780604307	584 Count	488 Count	89 Count
1780602503	583 Count	487 Count	89 Count
1780600700	582 Count	487 Count	89 Count
1780598896	581 Count	485 Count	89 Count
1780597092	580 Count	485 Count	89 Count
1780595288	579 Count	484 Count	89 Count
1780593485	578 Count	484 Count	89 Count
1780591681	577 Count	483 Count	89 Count
1780589878	576 Count	482 Count	89 Count
1780588074	575 Count	482 Count	89 Count
1780586270	574 Count	481 Count	89 Count
1780584466	573 Count	481 Count	89 Count
1780582704	568 Count	481 Count	89 Count
1780580902	567 Count	480 Count	89 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)