APRS Track Direct

My position About ☰

reset

OK1OBR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1780611390	12 Count	358 Count
1780609587	9 Count	314 Count
1780607783	8 Count	259 Count
1780605980	7 Count	211 Count
1780604177	6 Count	159 Count
1780602415	3 Count	116 Count
1780600612	2 Count	82 Count
1780598809	1 Count	43 Count
1780597005	31 Count	1037 Count
1780595202	28 Count	998 Count
1780593398	27 Count	954 Count
1780591595	26 Count	919 Count
1780589791	25 Count	868 Count
1780587987	22 Count	811 Count
1780586184	21 Count	767 Count
1780584381	20 Count	715 Count
1780582576	19 Count	664 Count
1780580813	16 Count	618 Count
1780579009	15 Count	566 Count
1780577205	14 Count	523 Count
1780575402	13 Count	481 Count
1780573599	11 Count	437 Count
1780571795	10 Count	378 Count
1780569992	9 Count	327 Count
1780568188	8 Count	283 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)