APRS Track Direct

My position About ☰

reset

3Z2T-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1740208168	222	924	408	102
1740206367	220	911	408	50
1740204570	218	905	408	50
1740202770	216	896	408	50
1740200973	214	890	408	50
1740199174	212	880	408	50
1740197375	210	874	408	50
1740195577	208	866	408	50
1740193780	206	859	408	50
1740191980	204	851	408	50
1740190181	202	845	408	50
1740188382	200	837	408	50
1740186582	198	830	408	50
1740184784	196	821	408	50
1740182985	194	816	408	50
1740181185	192	806	408	50
1740179386	190	800	408	50
1740177588	188	792	408	50
1740175788	186	786	408	50
1740173990	184	778	408	50
1740172190	182	772	408	50
1740170391	180	764	408	50
1740168590	178	758	408	50
1740166792	176	750	409	50
1740164992	174	744	409	50

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)