APRS Track Direct

My position About ☰

reset

VK3XEM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK3XEM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791108688	407 Count	27 Count	27 Count
1791107784	406 Count	27 Count	27 Count
1791106880	405 Count	27 Count	27 Count
1791105976	404 Count	27 Count	27 Count
1791105071	403 Count	27 Count	27 Count
1791104270	402 Count	27 Count	27 Count
1791103366	401 Count	27 Count	27 Count
1791102462	400 Count	27 Count	27 Count
1791101558	399 Count	27 Count	27 Count
1791100652	398 Count	27 Count	27 Count
1791099748	397 Count	27 Count	27 Count
1791098844	396 Count	27 Count	27 Count
1791097940	395 Count	27 Count	27 Count
1791096131	393 Count	27 Count	27 Count
1791095227	392 Count	27 Count	27 Count
1791094323	391 Count	27 Count	27 Count
1791093418	390 Count	27 Count	27 Count
1791092514	389 Count	27 Count	27 Count
1791091610	388 Count	27 Count	27 Count
1791090706	387 Count	27 Count	27 Count
1791089801	386 Count	27 Count	27 Count
1791088897	385 Count	27 Count	27 Count
1791087992	384 Count	27 Count	27 Count
1791087088	383 Count	27 Count	27 Count
1791086183	382 Count	27 Count	27 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)