APRS Track Direct

My position About ☰

reset

SQ9IDT-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9IDT-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791128179	173 Count	943 Count	137 Count
1791126379	162 Count	859 Count	127 Count
1791124603	147 Count	708 Count	117 Count
1791122802	130 Count	589 Count	101 Count
1791121001	113 Count	520 Count	85 Count
1791119198	99 Count	452 Count	72 Count
1791117398	87 Count	396 Count	61 Count
1791115597	75 Count	281 Count	50 Count
1791113795	61 Count	205 Count	37 Count
1791111988	37 Count	125 Count	24 Count
1791110187	22 Count	52 Count	14 Count
1791108386	212 Count	1018 Count	192 Count
1791104785	178 Count	910 Count	168 Count
1791102984	163 Count	846 Count	154 Count
1791101184	148 Count	776 Count	140 Count
1791099383	132 Count	704 Count	125 Count
1791093981	84 Count	418 Count	80 Count
1791092181	67 Count	321 Count	64 Count
1791090380	50 Count	237 Count	48 Count
1791088579	35 Count	167 Count	34 Count
1791086779	18 Count	90 Count	18 Count
1791084978	207 Count	1051 Count	192 Count
1791083177	190 Count	946 Count	176 Count
1791081392	172 Count	862 Count	163 Count
1791079592	156 Count	772 Count	148 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)