APRS Track Direct

My position About ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769639985	716 Count	129 Count	43 Count
1769639084	710 Count	126 Count	43 Count
1769638183	703 Count	122 Count	43 Count
1769637283	697 Count	119 Count	43 Count
1769636382	691 Count	115 Count	43 Count
1769635481	684 Count	112 Count	43 Count
1769634580	677 Count	108 Count	43 Count
1769633679	671 Count	105 Count	42 Count
1769632778	664 Count	102 Count	42 Count
1769631878	658 Count	98 Count	42 Count
1769630977	651 Count	95 Count	42 Count
1769630076	646 Count	93 Count	42 Count
1769629176	638 Count	90 Count	42 Count
1769628275	633 Count	88 Count	42 Count
1769627374	626 Count	85 Count	42 Count
1769626473	619 Count	83 Count	42 Count
1769625591	613 Count	82 Count	42 Count
1769624690	608 Count	80 Count	42 Count
1769623789	599 Count	77 Count	42 Count
1769622888	594 Count	75 Count	42 Count
1769621987	588 Count	75 Count	42 Count
1769621086	581 Count	75 Count	42 Count
1769620185	575 Count	74 Count	42 Count
1769619284	569 Count	72 Count	42 Count
1769618383	560 Count	71 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)