APRS Track Direct

My position About ☰

reset

SP2WM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791149666	447 Count	623 Count	183 Count
1791148765	446 Count	623 Count	183 Count
1791147865	445 Count	623 Count	183 Count
1791146964	444 Count	623 Count	183 Count
1791146064	443 Count	623 Count	183 Count
1791145162	442 Count	623 Count	183 Count
1791144261	441 Count	623 Count	183 Count
1791143361	440 Count	623 Count	183 Count
1791142478	435 Count	623 Count	183 Count
1791141577	434 Count	623 Count	183 Count
1791140676	433 Count	623 Count	183 Count
1791139775	432 Count	623 Count	183 Count
1791138874	430 Count	621 Count	182 Count
1791137974	428 Count	618 Count	181 Count
1791137073	426 Count	613 Count	180 Count
1791136172	424 Count	610 Count	179 Count
1791135272	422 Count	606 Count	178 Count
1791134370	420 Count	602 Count	177 Count
1791133470	418 Count	597 Count	176 Count
1791132569	416 Count	595 Count	175 Count
1791131668	415 Count	595 Count	175 Count
1791130767	414 Count	593 Count	175 Count
1791129867	412 Count	589 Count	174 Count
1791128966	411 Count	588 Count	174 Count
1791128065	409 Count	587 Count	173 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)