APRS Track Direct

My position About ☰

reset

SQ5LTL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5LTL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791077723	132 Count	364 Count	60 Count
1791075929	131 Count	361 Count	60 Count
1791074128	130 Count	358 Count	60 Count
1791072325	129 Count	355 Count	60 Count
1791070524	128 Count	352 Count	60 Count
1791068723	127 Count	349 Count	60 Count
1791066923	126 Count	341 Count	60 Count
1791065124	125 Count	338 Count	60 Count
1791063323	124 Count	335 Count	60 Count
1791061524	123 Count	333 Count	60 Count
1791059723	122 Count	331 Count	60 Count
1791057924	121 Count	329 Count	60 Count
1791056123	119 Count	326 Count	59 Count
1791054324	117 Count	323 Count	58 Count
1791052523	116 Count	319 Count	58 Count
1791050724	114 Count	316 Count	57 Count
1791048923	113 Count	314 Count	57 Count
1791047125	112 Count	312 Count	57 Count
1791045324	111 Count	305 Count	57 Count
1791043523	110 Count	303 Count	57 Count
1791039924	108 Count	299 Count	57 Count
1791038123	107 Count	297 Count	57 Count
1791036323	106 Count	295 Count	57 Count
1791032724	104 Count	291 Count	57 Count
1791030923	103 Count	289 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)