APRS Track Direct

My position About ☰

reset

F5ZYM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5ZYM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791118990	318 Count	833 Count	159 Count
1791118086	316 Count	829 Count	158 Count
1791117182	314 Count	823 Count	157 Count
1791116278	313 Count	820 Count	157 Count
1791115374	311 Count	815 Count	156 Count
1791114470	309 Count	811 Count	155 Count
1791113565	307 Count	807 Count	154 Count
1791112661	306 Count	804 Count	154 Count
1791111757	305 Count	801 Count	154 Count
1791110852	303 Count	799 Count	153 Count
1791109948	301 Count	793 Count	152 Count
1791109044	300 Count	785 Count	152 Count
1791108140	299 Count	781 Count	152 Count
1791107236	297 Count	777 Count	151 Count
1791106332	295 Count	772 Count	150 Count
1791105428	293 Count	767 Count	149 Count
1791104524	291 Count	762 Count	148 Count
1791103620	286 Count	753 Count	144 Count
1791102716	284 Count	746 Count	143 Count
1791101812	282 Count	740 Count	142 Count
1791101003	280 Count	736 Count	141 Count
1791100099	278 Count	731 Count	140 Count
1791099195	276 Count	727 Count	139 Count
1791098291	274 Count	721 Count	138 Count
1791097394	272 Count	717 Count	137 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)