APRS Track Direct

My position About ☰

reset

SP6DJA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6DJA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1764981691	274 Count	17 Count	2 Count
1764981631	273 Count	17 Count	2 Count
1764981570	272 Count	17 Count	2 Count
1764981509	271 Count	17 Count	2 Count
1764981448	270 Count	17 Count	2 Count
1764981388	269 Count	17 Count	2 Count
1764981327	268 Count	17 Count	2 Count
1764981267	267 Count	17 Count	2 Count
1764981206	266 Count	17 Count	2 Count
1764981145	265 Count	17 Count	2 Count
1764981084	264 Count	17 Count	2 Count
1764981024	263 Count	17 Count	2 Count
1764980963	262 Count	17 Count	2 Count
1764980902	261 Count	17 Count	2 Count
1764980842	260 Count	17 Count	2 Count
1764980781	259 Count	17 Count	2 Count
1764980720	258 Count	17 Count	2 Count
1764980660	257 Count	17 Count	2 Count
1764980599	256 Count	17 Count	2 Count
1764980538	255 Count	17 Count	2 Count
1764980477	254 Count	17 Count	2 Count
1764980416	253 Count	17 Count	2 Count
1764980356	252 Count	17 Count	2 Count
1764980295	251 Count	17 Count	2 Count
1764980234	250 Count	17 Count	2 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)