APRS Track Direct

My position About ☰

reset

SP8HDC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8HDC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785835546	766 Count	337 Count	308 Count
1785833753	753 Count	310 Count	308 Count
1785831952	743 Count	308 Count	307 Count
1785830152	742 Count	308 Count	307 Count
1785828351	741 Count	308 Count	307 Count
1785826550	740 Count	308 Count	307 Count
1785824749	739 Count	308 Count	307 Count
1785822949	738 Count	308 Count	307 Count
1785821148	737 Count	308 Count	307 Count
1785819347	735 Count	307 Count	306 Count
1785817547	734 Count	307 Count	306 Count
1785815746	733 Count	307 Count	306 Count
1785813945	732 Count	307 Count	306 Count
1785812152	731 Count	307 Count	306 Count
1785810351	729 Count	306 Count	305 Count
1785808550	728 Count	306 Count	305 Count
1785806750	727 Count	306 Count	305 Count
1785804949	725 Count	305 Count	304 Count
1785803148	723 Count	304 Count	303 Count
1785801348	722 Count	304 Count	303 Count
1785799547	721 Count	304 Count	303 Count
1785797746	720 Count	304 Count	303 Count
1785795946	719 Count	303 Count	303 Count
1785794145	718 Count	303 Count	303 Count
1785792344	717 Count	303 Count	303 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)