APRS Track Direct

My position About ☰

reset

SP4HMU-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4HMU-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791121283	116 Count	865 Count	58 Count
1791120682	115 Count	849 Count	58 Count
1791120081	113 Count	835 Count	57 Count
1791119481	111 Count	822 Count	56 Count
1791118880	110 Count	808 Count	56 Count
1791118279	108 Count	794 Count	55 Count
1791117679	106 Count	781 Count	54 Count
1791117078	105 Count	767 Count	54 Count
1791116478	103 Count	755 Count	53 Count
1791115877	101 Count	742 Count	52 Count
1791115276	100 Count	726 Count	52 Count
1791114676	98 Count	712 Count	51 Count
1791114075	96 Count	697 Count	50 Count
1791113474	95 Count	682 Count	50 Count
1791112874	93 Count	668 Count	49 Count
1791112273	91 Count	656 Count	48 Count
1791111672	90 Count	642 Count	48 Count
1791111072	88 Count	630 Count	47 Count
1791110471	86 Count	616 Count	46 Count
1791109871	85 Count	596 Count	46 Count
1791109270	83 Count	582 Count	45 Count
1791108669	81 Count	568 Count	44 Count
1791106867	76 Count	534 Count	42 Count
1791106266	75 Count	523 Count	42 Count
1791105666	73 Count	510 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)