APRS Track Direct

My position About ☰

reset

SQ6OXF-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ6OXF-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769646343	662 Count	325 Count	98 Count
1769645442	661 Count	324 Count	98 Count
1769644541	660 Count	324 Count	98 Count
1769643640	659 Count	323 Count	98 Count
1769642739	658 Count	323 Count	98 Count
1769641839	657 Count	322 Count	98 Count
1769640938	656 Count	322 Count	98 Count
1769640037	655 Count	321 Count	98 Count
1769639136	654 Count	321 Count	98 Count
1769638236	653 Count	320 Count	98 Count
1769637335	652 Count	320 Count	98 Count
1769636434	651 Count	319 Count	98 Count
1769635534	650 Count	319 Count	98 Count
1769634649	649 Count	318 Count	98 Count
1769633749	648 Count	318 Count	98 Count
1769632848	647 Count	317 Count	98 Count
1769631947	646 Count	317 Count	98 Count
1769631047	645 Count	316 Count	98 Count
1769630146	644 Count	316 Count	98 Count
1769629245	643 Count	315 Count	98 Count
1769627444	641 Count	314 Count	98 Count
1769626543	640 Count	314 Count	98 Count
1769625643	639 Count	313 Count	98 Count
1769624742	638 Count	313 Count	98 Count
1769623841	637 Count	312 Count	98 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)